24 December 2007

The Joule Thief

I had it ready for months, but never finalized. This Xmas 2007 we needed a simple way to light the Nativity scene, so I took the chance to get it working.



I used the joule thief in its simplest form, as probably published November 1999 issue of EPE (Everyday Practical Electronics). It's a NPN transistor, one resistor, a bifilar transformer and a LED (any color). I found the diagram on the web and worked immediately.


Lighted using a dead saline battery.


Lighted using a dead saline battery. No flash.


The Nativity scene, with room lights ON.

The Nativity scene, with room lights OFF.

How did I wind the transformer? I saw many questions about it around the web. First of all, you need some luck since you're probably winding it on a core with unknown characteristics. I took some length of enameled copper wire (2 metres), bent in half and wound about 8 turns through the core. Windings are spread about on 80% of the core. The core is a ferrite bead recovered from WhoKnowsWhereLand. Try it first with a fresh battery. If it doesn't lit, add some turns and try again. If at 20 turns you still don't get light, then:
  • check your LED is wired properly
  • change the core
Don't forget to scrape off the insulation from the enameled wire at solder points!

Before someone asks, no, I have no spare cores to send around.

With the saline battery my joule thief produced noticeable light (in darkness) for 36 uninterrupted hours. I will measure how much current it draws at the next battery change.